Welcome to Suzhou Xin Weize Photoelectric Technology Co., Ltd

Committed to the photoelectric industry

Innovation development Self-motivated

Consultation telephone:

18013762091

18994479186

Your location: Home > News >

News

Contact Us

Company Name: 
Suzhou Xin WeiZe Photoelectric Technology Co., Ltd
Tel: 18013762091
    18994479186
AM8:30  - PM17:00 Monday to Friday (Except Holidays)
Address: No. 283, Qianqiao Road, High Tech Zone, Suzhou

News

Precautions for painting in Suzhou

Author: ComeFrom: Date:2022/5/11 14:23:23 Hits:254

I'm confused about the massive amount of Suzhou paint.

1. Oil treatment before coating is very important. It is incorrect to see that people use self spraying paint, which is usually simply cleaned, wiped with a rag, or even sprayed directly. The correct method is to use detergent and wash carefully. It is not only necessary to pour out dust, but mainly clean oil, including oil and sweat. These oils are the enemy of self painting, and one of the main reasons for easy falling off is oil. Don't trust your eyes. Just because you can't see fat doesn't mean it doesn't exist.

2. Before painting, polish or polish it (Cu PAO). The purpose is to remove substances that are not easily soluble in water and detergents, such as oxides, while polishing can also increase the surface area of painting (carefully consider) and improve the adhesion of painting.

3. Self spray method. Shake the bottle repeatedly before painting and fully stir the acrylic acid. Keep it about 20 cm away. If it is too close, it is easy to bubble and accumulate, and the area too far will cause waste. Pay attention to the wind speed. Wind grade 2 (including above grade 2) is not suitable for self spraying. Pay attention to dust prevention, dust prevention and small insects often cause trouble. Pay attention to temperature and humidity to prevent exposure or excessive humidity and low temperature. Each layer is thin. After a few minutes, repeat several times. If you want to shoot at one stroke, you need to shoot less. Count down the spray several times after use, and then keep it in a cool place.

4. Use a wallpaper knife and scotch tape. If not satisfied, grind after spraying (2000 × After re spraying with sandpaper and lubricating oil, it can be repeated for many times until the effect is satisfactory. Light oil or sand can be used appropriately. Use protective wax to prevent oxidation and tarnishing of paint.

5. The coating is generally about 3 years. You need to polish it with sand wax. Some forum moyou cans can remain fresh for several years. Some reasons for using sand wax. The effect of sand wax on slight sliding marks of helmet and fuel tank may be good. Different from the solidified wax, the solidified wax cannot be used frequently. The solidified wax can be used after each cleaning. If there is no new damage, the solidified wax is generally used every 1-3 years.

1. For the same work, choose the same batch and color painting, so as not to cause color difference and the effect will be better.

2. Before painting, the painting must be tested to see the color effect, so that the painting can achieve the expected effect.

3. Shake the spray tank about two minutes before spraying to make the paint in the spray tank uniform, so as to achieve better spraying effect.

4. When painting, the spraying tank must be kept at a certain distance from the surface, and then paint at a uniform speed to make the spraying more uniform. It cannot be sprayed directly to prevent the paint from falling.

5. After spraying, if the paint in the oil tank is not used up, it must be sprayed back to prevent the gas in the tank from blocking the tank mouth to avoid scrapping.

Next:Nothing
Copyright(C)2009-2022 Suzhou xinweize Photoelectric Technology Co., Ltd Record number:苏ICP备2022017746号-1 technical support:仕德伟科技